Fillers

A single component conventional filler. Use for spot filling minor blemishes and screwheads above the waterline. When filling larger areas, you may need to apply several layers as Unifiller shrinks on curing.

Minimum application temperature: 5°C.

Thinner/Tool cleaner: Thinner No 3

Film thickness: 0.5 mm per coat

Temp	Touch dry	Re-coat (min/max)
10°	4.5 hours	7 hours
20°	2 hours	3 hours

Tools:

A two component, solvent free, epoxy filler. Use for a variety of filling and fairing jobs both above and below the waterline. Can be applied in thick coats up to approximately 5mm without runs or sags. Fair before overcoating with relevant primer.

Minimum application temperature: 5°C.

Thinner/Tool cleaner: Thinner No 5

Film thickness: 5mm per coat

Temp	Touch dry	Re-coat (min/max)
10°	16 hours	16 / 48 hours
20°	8 hours	8 / 24 hours

Tools:

ProFiller 35370 is a two-component lightweight epoxy filler, with high adhesion and water resistance, and when fully cured easy to sand. Can be applied in coats up to 10-12mm for a uniform smooth film build. Especially suitable for pro filling large areas and detailed fairing where structural strength is important. It can be used on most primed substrates, above and below the waterline.

Minimum application temperature: 5°C.

Thinner/Tool cleaner: Degreaser 99610 or Thinner No 5

Film thickness: 1.0 m2/litre – 1 mm

Temp	Touch dry	Re-coat (min/max)
10°	12 hours	16 / None
20°	6 hours	8 / None

Tools: